通信電纜 網絡設備 無線通信 云計算|大數據 顯示設備 存儲設備 網絡輔助設備 信號傳輸處理 多媒體設備 廣播系統 智慧城市管理系統 其它智慧基建產品
樂清威創防爆科技有限公司
樂清威創防爆科技有限公司
| 參 考 價 | 面議 |
產品型號
品 牌
廠商性質生產商
所 在 地溫州市
聯系方式：江鵬龍查看聯系方式
更新時間：2018-05-14 09:00:00瀏覽次數：978次
聯系我時，請告知來自 智慧城市網暫無信息 |
BAY51-2*40W防爆熒光燈，CBY52防爆抽芯式熒光燈主要適用于爆炸性氣體環境中1區或2區危險區域，爆炸性氣體為Ⅱ類，A、B級，溫度組別T1~T6場所，在交流50Hz、額定電壓220V的電路中，作為工作場所戶內、戶外照明用。可配有應急裝置，應急熒光燈為事故停電或斷電時應急照明用。
BAY51-2*40W防爆熒光燈，CBY52防爆抽芯式熒光燈 防爆熒光燈，BAY51-2*40W，防爆抽芯式熒光燈，CBY52防爆熒光燈
BAY51-2*40W防爆熒光燈用途與使用范圍
BAY51-2*40W防爆熒光燈技術參數
| 電源電壓（V） | 功率（W） | 燈頭型號 | 防爆標志 | 防護等級 |
| AC220 | 1×20、2×20 | G13 | ExdeⅡBT6 | IP54 |
| 1×30、2×30 | ||||
| 1×40、2×40 |
帶應急熒光燈技術參數
BAY51-2*40W防爆熒光燈主要結構
The main structure
熒光燈由燈具和接線盒兩部分組成，燈具兩端用鑄鋁合金壓鑄外殼，表面噴塑，燈芯部分為一整體，包括支架、燈管、鎮流器、啟輝器等，更換燈管時先斷開電源，然后打開端蓋，斷開安全電源插頭，將燈芯部分整體抽出。把燈管向彈簧側移動后，可將燈管取下。熒光燈外部裝有防塵罩。熒光燈為復合型結構，燈具主腔為隔爆型結構，接線腔為增安型。接線盒為隔爆型，電纜采用直接引入方式，電纜引入裝置從內到外依次裝有密封圈、墊圈和壓緊螺母，適合電纜或鋼管布線。接線盒設有內接地螺釘，燈具設有外接地螺釘。
The fluorescent lamp comprises a lamp and the junction box is composed of two parts, lamp at both ends of cast aluminum alloy die casting shell, surface spray, the wick part as a whole, comprises a bracket, lamp, ballast, starter, replacement of lamp to disconnect the power, and then open the side cover, disconnect the safety power supply plug, the wick is part of a whole extract. The lamp tube to move the spring side, a luminous tube can be removed. Fluorescent lamp is arranged outside of the dust cover. Fluorescent lamp is a composite structure, the main chamber lamps for flameproof structure, wiring cavity is Increased-Safety type. Junction boxes for explosion-proof type, the direct introduction of cable, cable introducing device from the inside to the outside is provided with a sealing ring, a washer and nut, suitable for cable or steel pipe wiring. The junction box is provided with a grounding screw, lamp equipped with external screw.
BAY51-2*40W防爆熒光燈使用與維修
5 use and repair
5.1安裝前應檢查熒光燈銘牌上所列數據是否與實際使用條件相符；
5.1 installation should be checked before the fluorescent lamp nameplate on the column data is consistent with the actual conditions of use;
5.2應檢查電纜外徑是否適合密封圈尺寸；
5.2 should check the cable diameter is suitable for the size of the seal ring;
5.3安裝前，將接線盒蓋和燈具引入裝置打開，把電纜一端接接線盒內接
5.3 before installation, the junction box and lamp into the device is opened, the cable is connected to the junction box inscribed
線端子上，把電纜另一端穿過管接頭及墊圈、密封圈到燈具接線腔內接到接線端子上，將各部分連接好，把連接好的熒光燈固定在使用位置，把電源電纜線依次穿過引入裝置的壓緊螺母、墊圈和密封圈接至接線盒內接線端子上，接好接地線，緊固壓緊螺母使電纜密封，不用的引入裝置用堵棒、密封圈及壓緊螺母密封好。合上接線盒蓋，緊固好螺栓即可使用；
Line terminal, the other end of the cable through the pipe joint and gasket, sealing ring to the lamp wiring cavity to the terminal, each part is connected, the fluorescent lamp is connected well fixed in position, the power supply cable passes through the device of pressing nut, the gasket and sealing ring is connected to the terminal box terminal, connect the ground wire, fastening nut so that the cable sealing, introducing device without with blocking rod, sealing ring and a pressing nut sealed. Close the terminal cover, fastening bolts can be used;
5.4熒光燈不得隨意拆卸，維修時先斷開前級電源后，才能開蓋維修。打開端蓋，斷開安全電源插頭，將燈芯部分整體抽出。注意：只有在拔掉插頭后，才能把燈芯部分抽出。把燈管向彈簧側移動后，可將燈管取下。維修時不得損壞隔爆面，維修后隔爆接合面清理后涂204-1防銹油，將端蓋合上，各部分螺栓（釘）緊固后才能使用；
The 5.4 fluorescent lamps shall not disassemble, repair to disconnect the power supply before class, can open the cover repair. Open the cover, disconnect the safety power plug, the wick is part of the overall extraction. Note: only pull the plug, to put the wick part out. The lamp tube to move the spring side, a luminous tube can be removed. Repair shall not be damaged flameproof surface, after the repair of flameproof joint after cleaning with 204-1 antirust oil, the end cover is closed, the bolt （screw） fastening to use;
5.5熒光燈應定期檢查，發現電纜引入裝置的密封圈及密封墊老化變質及其他零件損壞應及時更換；
5.5 fluorescent lamp should be regularly checked, found the ring cable introducing device and a seal gasket aging deterioration and other parts damaged should be replaced promptly;
5.6帶應急功能熒光燈接線應使控制器始終處于供電狀態，給電池充電，斷電時電池組能立即向燈管供電，在出廠后，若沒有使用應每隔2~3個月充電一次，充電時間不能少于24h。
5.6 with emergency function of fluorescent lamp wiring should make the controller is always in the state of power supply, battery, power battery can immediay to the lamp power supply, at the factory, if not used should be every 2~3 months on a charge, the charging time of not less than 24h.
BAY51-2*40W防爆熒光燈外形及安裝尺寸
6 appearance and installation dimensions
產品型號 L1 L2 產品型號 L1 L2
The product model L1 L2 product model L1 L2
BAY51-1×20 673.5 779 BAY51-2×20 677.5 779
BAY51-1 × 20673.5779 BAY51-2 × 20677.5779
BAY51-1×30 978.5 1084 BAY51-2×30 982.5 1084
BAY51-1 × 30978.51084 BAY51-2 × 30982.51084
BAY51-1×40 1383.5 1389 BAY51-2×40 1387.5 1389
BAY51-1 × 401383.51389 BAY51-2 × 401387.51389
專業生產：防爆配電箱,鑄鋁防爆箱,不銹鋼防爆箱,防爆接線箱,防爆照明配電箱,防爆動力配電箱,防爆配電柜,防爆控制箱,BZC51防爆操作柱,防爆應急燈,防爆熒光燈,防爆無極燈廠家,防爆正壓柜,防爆投光燈,柳市防爆箱,防爆斷路器等，質量三包，凡購買本公司產品，質保三年，本公司證件齊全，價格實惠！
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
智慧城市網 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
